TUF-TITE CATALOG ON THE WEB



Tuf-Tite Corporation Drainage and Septic Products 500 Capital Drive Lake Zurich, Illinois 60047 800-382-7009 847-550-1011 Fax: 847-550-8004 e-mail us -------------------- Home ------------------- 4-Hole Dist. Box ------------------- 6-Hole Dist. Box ------------------- 7-Hole Dist. Box ------------------- 9-Hole Dist. Box ------------------- Drain Sump ------------------- Effluent Filter ------------------- Gas Baffle® ------------------- Round Riser ------------------- Speed Leveler® -------------------- Trench Drains ------------------- Chemical Resistance Chart - HTML ONLY -------------------
		CLICK HERE for the full-size, printable PDF file of this literature.

	9-Hole Distribution Box Tough Problem: Providing a simple, reliable, and permanent means for dividing septic tank effluent flow. TUF-TITE Solution: A strong, stable, permanent, non-corrosive Tuf-Tite Distribution Box, with a Tuf-Tite Speed Leveler in each outlet. Tuf-Tite® Distribution Box. THE TOUGH ONE! • Injection molded HDPE • Non-corrosive • Simple to install • Easy to level In a septic environment, no other material can match High Density Polyethylene in delivering a lifetime of trouble-free service. Tuf-Tite Distribution Boxes are injection molded, using only premium HDPE which contains no fillers or foam. Snap-in pipe seals They’re patented. Simply insert your PVC pipe and push it through the flexible, polyethylene Tuf-Tite seal. Pipes fit watertight. Installation couldn’t be easier. They’re permanent Unlike cement-based pipe grout, Tuf-Tite seals will not crack or corrode in septic conditions. They stay pliable and watertight permanently.		• Injection molded. Exceptionally strong. • HDPE is non-corrosive in a septic environment. • Patented snap-in pipe seals simplify installation. Domed Lid. Heavy-duty HDPE Lid is ribbed and domed for exceptional strength. Slotted sides interlock on the Distribution Box to assure a tight fit. The 9HD2 Distribution Box comes complete with a Domed Lid, 11 snap-in fittings of your choice, and a Plastic Handle should a precast concrete lid be used. INSTALLATION IS JUST THIS SIMPLE 1. Position the Distribution Box on level virgin soil. Do not place box on a concrete slab. 2. Install the inlet pipe and outlet pipes. Be sure the bottoms of all pipes rest on virgin soil. 3. Level the Distribution Box and all pipes as needed. 4. Backfill the pipes to within two feet of the Distribution Box. Recheck the level of the box, then backfill up to the top lid ridge. 5. Install and adjust Tuf-Tite Speed Levelers. 6. Place lid on the Distribution Box and finish backfilling.